1. Use a small phillips screw driver to adjust the
FlexTilt screw on the top of the Panel to
achieve the desired camera angle.
NOTE: Turning the screw clockwise angles the camera
down. Turning the screw counter-clockwise angles the
camera up.
2. Arm/Disarm the Panel to capture a Disarm
Photo and test the FlexTilt position. Adjust
as needed.
FlexTilt camera adjustment allows the built-in Panel Camera to be angled up
or down depending on the installation need. This is especially helpful when
wall mounting over an existing keypad location that may be higher or lower
than usual, or when table stand mounting.
To Next Page
Loading...
