Most updates are downloaded over Wi-Fi, but in the event that Wi-Fi is not present at the
installation site, a Panel can be updated with files transferred from a local device (phone,
tablet, computer, etc) via the built-in Panel Access Point.
To perform a software update using the Panel Access Point follow the steps below:!
1- Download the needed software update files from the Dealer Portal to your device (phone,
tablet, computer).
2- Turn on the Panel AP and connect your device to the network it broadcasts.
3-!Go to Settings/Advanced
Settings/Upgrade Software then
touch “Upgrade Using Access Point”.
4- Press “Start” to begin the local
server session, then from your device,
navigate to the “https” site shown on
the Panel screen.
5- Follow the prompts on your device
screen to select the correct files and
transfer them to the Panel.
NOTE: For UL/cUL the remote
software feature shall not be
used and the panel shall not be
setup to remotely upgrade.
To Next Page
Loading...
