LED indicator status
LED status Indication Action
The LED is off The unit is not connected to
the panel. The power from
the panel is out. The unit is
damaged
Verify the wiring, refer to the
wiring diagram. Measure
the AUX output of the panel.
Replace the unit
Slow flashing Trying to establish connection.
There is no signal available
Reposition the antenna
Constantly ON, blinking every 5
seconds
Connection established at low
signal level
Reposition the antenna
Blinking – 2 seconds ON, 1
second OFF
Server to Monitoring Station
connection error
Constantly on Connection established at good
signal
Fast blinking Transferring data
Troubleshooting
If you have issues receiving the events:
1. Verify the communicator is connected to the network.
2. Verify the PC link cable is properly connected - refer to the communicator wiring sections.
3. Verify that the DSC PowerSeries/PowerSeries Neo alarm panel is properl programmed.
Device registration in the DSC installer portal and DSC
connect installer app
Register your company at https://connect.dsc.com or use your existing account to login the web
portal
Adding monitoring station reporting channel
Contact your monitoring station and request your Dealer Code.
Login to the DSC Installers Portal and add monitoring station reporting channels from My Devices >
Monitoring Stations > Add Reporting Channel:
• Choose your preferred monitoring station from the Partner Monitoring Stations List.
• Type in the Dealer Code and Save to submit your request to the monitoring station.
Adding a new device
Make sure you have the device Serial Number and the Config Key from the leaflet provided with the
device package.
Adding a device from the DSC installer web portal
1. Go to My Devices > Devices > Add New Device.
2. Select the preferred monitoring station/reporting channel.
3. Type in the device Serial Number and Config Key and Save.
15LE4050M INSTALLATION MANUAL
To Next Page
Loading...
Need help?
General