Johnson Controls MAP 1810 - Connect the MAP Gateway to Equipment; MAP Gateway LED Indicators; Connect to the MAP Gateway Wi-Fi Network; Open a Web Browser Interface

ENGLISH - Quick Start Guide
1
Connect the MAP Gateway to Equipment
If you are going to use the MAP Gateway on Ethernet,
you must plug it into external power before you attach
the eld bus adapter. Use the supplied RJ-12 cable
or eld bus adapter to connect the RS-485 port of the
MAP Gateway to the sensor bus or eld bus port of the
equipment controller.
The MAP Gateway LEDs ash,
indicating that the device is
initializing. When the Fault LED
turns off and the Wi-Fi LEDs ash
in succession, the MAP Gateway is ready to use.
2
Connect to the MAP Gateway
Wi-Fi Network
In the Wi-Fi settings of your mobile device or laptop,
connect to the MAP Gateway Wi-Fi network using your
credentials.
3
Open a Web Browser
Direct your browser to www.mapgwy.com to open the
MAP Gateway browser interface.
MAP Gateway ships with a private mapgwy.com SSL
certicate installed to ensure secure communication
with the MAP Gateway. However, this certicate does
not indicate that it is trusted in a browser. If you wish to
install your own certicate, refer to Installing a Security
Certicate on a Client That is Connecting to MAP