Johnson Controls Metasys BTCVT User Manual

Bluetooth wireless adapter is installed and configured, you do not need to configure it again until
software or hardware configurations change.
Bluetooth Quick Start Guide
This quick start guide leads you through the Bluetooth device setup for Windows 7 and Windows
10. Your steps may vary depending on the vendor of the Bluetooth wireless device and your
operating system.
You must repeat these steps for each Bluetooth converter you set up, as each device is assigned its
own COM port.
Setting up the BTCVT Wireless Commissioning Converter
1. Plug your BTCVT Wireless Commissioning Converter into the SA BUS port or the FC BUS port on
your field controller.
Figure 1: SA BUS and FC BUS Port
2. On the BTCVT, verify that the Power LED is green, and that the Fault LED is off.
Metasys® CCT Bluetooth® Technology Communication Commissioning Guide4

Johnson Controls Metasys BTCVT Specifications

General

Brand	Johnson Controls
Model	Metasys BTCVT
Category	Media Converter
Language	English