Installation Sheet
Issue Date 0495
© 1995 Johnson Controls, Inc. 1
Part No. 24-7534-2
● flat-head screwdriver
● needle-nose pliers
● drill
The ZT unit measures 6.88 x 7.31 x 1.52 inch (175 x 186 x 39 mm), and
weighs 1.25 lb (0.57 kg). A coiled, 6-pin telephone-type cord is included.
The cord is 17 inches long and stretches to 5 feet. The ZT contains a
5-year lithium battery, factory installed.
The Wall Mount Base with ZT measures 6.94 x 7.44 x 2.00
(176 x189 x 51 mm).
The Utility Mount Base with ZT measures 6.94 x 7.44 x 6.00
(176 x 189 x 152 mm) when mounted on the ENC100.
Installation of the Zone Terminal must meet the following standards:
● Ambient operating conditions: 32 to 122°F (0 to 50°C)
● 10 to 90% non-condensing relative humidity
● 86°F (30°C) maximum dew point
Notes: Do not mount the Zone Terminal on a vibrating surface.
The atmosphere must be free of corrosive chemical vapors that
may damage electronic equipment.
● Use mild soap and water with a soft cloth to wipe surfaces of the ZT
clean.
● Do not immerse the ZT unit in water.
● Wipe clean with pure isopropyl alcohol, if surface becomes
excessively dirty.
Zone Terminal
Physical
Dimensions
Environmental
Information
Cleaning of ZT
To Next Page
Need help?
General
