Vertical Wallbox-Mounted or Surface-Mounted Occupancy Sensing NS Series Network Sensors with LCD
Installation Instructions
6
Technical Specifications
Vertical Wallbox-Mounted or Surface-Mounted Occupancy Sensing NS Series Network Sensors
with LCD (Part 1 of 2)
Supply Voltage 9.8 to 16.5 VDC; 15 VDC nominal (from SA Bus)
Current Consumption 21 mA maximum (non-transmitting)
Terminations Modular jack or screw terminal block
Network Sensor Addressing Fixed address of 199
Wire Size Modular Jack
Models
24 or 26 AWG (0.5 or 0.4 mm diameter); three twisted pair (six conductors)
Screw Terminal
Block Models
18 to 22 AWG (1.0 to 0.6 mm diameter); 22 AWG (0.6 mm diameter) recommended
Communication Rate Auto-detect: 9.6k, 19.2k, 38.4k, or 76.8k bps
Temperature Measurement
Range
32.0°F/0.0°C to 104.0°F/40.0°C
Temperature Sensor Type Local 1k Ohm platinum resistance temperature detector (RTD); Class A per IEC 60751
Temperature Resolution ±0.5F°/±0.5C°
Temperature
Accuracy
NS Series
Network Zone
Sensor
±1.0F°/±0.6C°
Temperature
Element Only
0.35F° at 70°F (0.2C° at 21°C)
Humidity
Accuracy
NS-MHB7004-x
Models
±3% RH for 20% to 80% RH at 77°F (25°C);
±6% RH for 10% to 20% RH and 80% to 90% RH at 77°F (25°C)
Time Constant 10 minutes nominal at 10 fpm airflow
Default Temperature Setpoint
Adjustment Range
50.0°F/10.0°C to 86.0°F/30.0°C in 0.5° increments
PIR Occupancy Sensor
Motion Detection
Minimum 94 Angular Degrees up to a distance of 15 ft (4.6 m);
based on a clear line of sight
Ambient
Conditions
Operating 32 to 104°F (0 to 40°C); 10 to 90% RH, noncondensing;
85°F (29°C) Maximum Dew Point
Storage -4 to 140°F (-20 to 60°C); 5 to 95% RH, noncondensing
To Next Page
Loading...
