TEC3000 Series Proportional Fan Coil and Individual Zone Thermostat Controllers with Dehumidification
Capability Installation Instructions
26
7. Set the Occupancy to Not Set, Occupied, Unoccupied, or Standby and press Save.
Figure 17: Selecting the Days (Left) and Selecting the Event (Right)
Figure 18: Setting the Room Occupancy (Left) and Setting the Occupancy Mode (Right)
8. Set the time to the time at which the event should occur and press Save.
Figure 19: Setting the Event Time (Left) and Viewing the Event Time (Right)
IMPORTANT: Internally, the TEC 3000 uses a BACnet schedule where daily schedules are independent of the
previous and next days. The default occupancy of the TEC3000 from the factory is set to Occupied. As a result,
a daily event at 12:00 AM must be scheduled if you do not want the controller to transition to Occupied Mode at
midnight.
To Next Page
Loading...
