Johnson Controls YVAHR192B32S - 5 Transportation and Installation Work; Transportation

P5417009-rev.6
19
● Donothangtheunitwiththeslingbeltsatthewoodenskidbase.
5. Transportation and Installation Work
5.1 Transportation
Transport the product as close to the installation location as practical before unpacking.
When using a crane, hang the unit according to the description on the outdoor unit packing slip.
● TransportationandStorage:
* The protective corrugated cardboard is not strong enough to resist rough handling.
* Secure with two sling belts when hoisting the outdoor unit with a crane.
● TransportationandBandingWire:
* To protect the unit, do not remove
any packing.
* Donotstackorplaceanymaterial
on top of the product.
* Apply banding wire to both sides of
the packaged unit as shown at right.
Sling Belt
Long Hole
Sling Belt Position
CORRECT INCORRECT
Wooden Skid Base
Sling Belt
Wooden Skid Base
Attach four 5/8 inch
(15mm) thick corrugated
corner pads as shown.
Wooden Skid Base
Corrugated
Paper Frame
Banding Wire
Do not remove
corrugated paper
frame and plastic
bands.
Plastic Bands