Johnson 40-6527 User Manual

6 ©2016 Johnson Level & Tool - Rev. 2
6. Operating Instructions
IMPORTANT: It is the responsibility of the user to verify the
calibration of the instrument before each use.
Battery Installation
Note: Always check to be sure that the on/off switch is in the off
position before removing and replacing batteries.
Usage for Rechargeable (40-6532 & 40-6539) & Alkaline Battery Cases
1. Put 4 “C” alkaline batteries into the battery case according to the
polarity indication shown in the battery case.
2. Put the battery case on the instrument and tighten the locking screw.
3. If using the rechargeable (40-6532 & 40-6539) battery pack, put
the battery box on the instrument and tighten the locking screw.
Note (40-6532 & 40-6539):
• For the first two charges of a new rechargeable battery pack, it is
necessary to charge for 12-plus hours.
• The instrument will still work even if it is being charged with the
charger.
• Do not charge alkaline batteries.
• Used (discharged) batteries are hazardous waste and should be
disposed of properly.
1625i-English_Manuals 12/28/16 9:41 AM Page 6

Johnson 40-6527 Specifications

General

Model	40-6527
Category	Measuring Instruments
Type	Digital Multimeter
Display	LCD
Power Source	Battery
Special Features	Diode Test, Continuity Test, Data Hold