© 2022 Johnson Level & Tool — 8
GETTING STARTED
x
2
: Squares a linear or non-dimensional
value.
Total Cost: Based on entry of per unit cost.
Store Weight per Volume: Stores a new
Weight per Volume value as listed below:
Note: After entering a value and pressing
Conv
0
, continue pressing the
0
digit
key until you’ve reached the desired
Weight per Volume format. To recall your
setting, press
Rcl
0
.
• Ton Per CU YD
• LB Per CU YD
• LB Per CU FEET
• MET Ton Per CU M
• kG Per CU M
This value is stored until you change it or
perform a Clear All (
Conv
×
).
On-Center Spacing (o.c.): Stores a new
on-center spacing (e.g.,
2
4
Inch
Conv
5
). The value is used for jack and rake
wall stud calculations. Default is 16".
Conv
Conv
Conv
Conv
•
0
5
√ x
To Next Page
Loading...
Need help?
General