© 2022 Johnson Level & Tool — 11
GETTING STARTED
PRESS
Conv
AND: SETTING — FUNCTION
Fifth press of
%
: Decimal Degree Displays:
– 0.00º
+
– FLOAt (floating point)
+
– 0.00º (repeats options)
Sixth press of
%
: Fractional Mode:
– Std.
+
– COnSt
+
– Std. (repeats options)
ENTERING DIMENSIONS
LINEAR DIMENSIONS
When entering Feet-Inch values, enter dimensions from
largest to smallest — Feet before Inches, Inches before
Fractions. Enter Fractions by entering the numerator (top
number), pressing
/
(Fraction Bar key) and then the
denominator (bottom number).
Note: If a denominator is not entered, the fractional
setting value is used.
Examples of how linear dimensions are entered (press
On/C
after each entry):
DIMENSIONS KEYSTROKE
6 Yards
6
Yds
5 Feet 1-1/2 Inch
5
Feet
1
Inch
1
/
2
58.5 Meters
5
8
•
5
m
To Next Page
Loading...
Need help?
General