Johnson CALC-1500 - Stair Layout and Settings; Calculator Settings and Preferences; Basic Operations and Conversions

TABLE OF CONTENTS
Entering Square and Cubic and
Adding a Waste Allowance ......................... 17
Weight Conversions ............................... 17
Weight per Volume ...............................18
Using the Memory ................................19
Board Feet and Cost ...............................20
Carpentry — Calculating Number of Studs ............20
Baluster Spacing .................................. 21
Circle Area and Circumference ......................22
Arc Angle or Degree ...............................22
Concrete Volume for Driveway ......................23
Concrete Columns .................................23
Complex Concrete Volume ..........................24
Right Angle/Framing ..............................26
Squaring-Up a Foundation .........................27
Pitch — Converting Roof Angle ......................27
Converting Slope .................................28
Common Rafter Length ............................28
Regular Hip/Valley and Jack Rafters ..................29
Irregular Hip/Valley ............................... 31
Rake-Wall — With Base ............................32
Stairs ............................................34
Stairs — Given Rise and Run ........................34
Stairs — Given Only the Floor-to-Floor Rise;
Entering Other Than 7-1/2 Inch Desired Riser Height ....36
TABLE OF CONTENTS