1514
STEP 4: Replace The Motor Cover
T R E A D M I L L T 7 0 0 0 P R O T R E A D M I L L T 7 0 0 0 P R O
a.Replace the motor cover on the treadmill using buttonhead cross screws (Z53) to
secure them.
b.In order to prevent the power cord pressed down by elevation rack when the treadmill
is elevated up or down, it is recommended to tie up the power cord on the motor
cover (Shown as picture)
STEP 5: Calibrate The Treadmill
Enter the Manager’s Custom Mode to execute P16 AUTO CHECK. The treadmill’s INCLINE
will be calibrated automatically. This will take around 1 minute to run. After the completion
of calibration, press EMERGENCY STOP key twice to back to the inital starting screen.
Z53*8
Z62
Z63
Z64
To Next Page
Loading...
