Page Issue A
Chapter - Health and Safety
7:7
CN101 - Maintenance
Solvents:
Solvents such as acetone, white spirit, toluene, xylene and trichloroethane are flammable.
Avoid splashes to the skin, eyes and clothing. Wear protective gloves, goggles and
clothing.
When using solvents ensure good ventilation; avoid breathing fumes, vapours, spray-
mists and keep containers tightly sealed. Do not use in confined spaces. When spraying
materials containing solvents, for example paints, adhesives or coatings, use extraction
ventilation or personal respiratory protection in the absence of adequate general
ventilation.
Do not apply heat or flame except under specific and detailed manufacturer’s instructions.
Suspended loads:
Never work under an unsupported, suspended or raised load. For example, jacked up
vehicle, raised tipper body, suspended engine, etc.
Always ensure that lifting equipment e.g., jacks, hoists, axle stands, slings, etc are
adequate and suitable for the job, in good condition and regularly maintained.
NEVER improvise lifting tackle. ALWAYS ensure body props and/or axle stands are used
when working under bodies or chassis.
Workshop tools and equipment:
Only use tools and equipment for their intended purposes.
Never overload equipment such as hoists, jacks, axles stands or lifting slings. Damage
caused by overloading is not always immediately apparent and may result in a fatal failure
the next time the equipment is used.
Never use damaged or defective tools or equipment.
Always wear suitable eye protection when using grinding, chiselling or air guns.
Always wear a suitable breathing mask when using sand blasting equipment, working with
asbestos based materials (such as brake linings) or using spraying equipment.
To Next Page
Loading...
