Johnston VT801 - Wanderhose Adjustment

Johnston Sweepers Limited
Chapter - Routine Maintenance
Page Issue 01
OG
6:11
V Range 501 ● 651 ● 801 - Operator’s Guide
WanderhoseAdjustment
Adjustment
The balance of the Wanderhose can be adjusted.
This is done by tightening or slackening the nuts
(A) on the two spring jack studs and should
only be done with the extension hose assembly
attached.
Adjustment is correct when the Wanderhose
boom tends to rise when released and only a
small effort is required to lower it. When the
Wanderhose without the extension assembly
is stowed, this adjustment should give effective
capacity in the stowage hook.
●Safetyplatform/gantrytobeusedforthisprocedure
Safety Notice
M02OG-100
A
All Copyright and rights are the property of Johnston Sweepers Ltd