2221
Installation -General
2 Position base on a forward
facing vehicle seat. Use
recline adjustment to position
bubble in indicator.
Adjust base so bubble is be-
tween the black patches.
3 Use recline adjustment, if
needed, to achieve correct
angle for installation. Recline
adjustment foot snaps into
position.
4 If the recline adjustment
foot does not give sufficient
recline, add a folded towel of
similar.
Installation - Base
IMPORTANT
Any extra padding placed
under the base must
be firmly folded so that
when the vehicle belts are
pulled up tight, the base
is secure.
Where to install the child
restraint?
Only install child restraint in a
forward facing vehicle seat.
Never install in a seat that
faces the rear or the side of the
vehicle.
Install in the rear seat, the
safest place is normally the
centre.
This is a rearward facing
child restraint. Do not install
facing side or forwards.
The base can be installed
on vehicles seats fitted with
either a lap belt or a lap/sash
belt.
1 To install correctly the
vehicle must be on a level
surface.
IMPORTANT
Correctly positioning the
child restraint is impor-
tant to ensure that in the
event of a crash the re-
straint can offer maximum
protection.
To Next Page
Loading...
Need help?
General
