109
FIRST CHECK SHOULDER
STRAP HEIGHT AND ADJUST
IF NECESSARY. See page 12
1 Loosen harness by
pressing on adjuster button
while pulling on the harness
straps.
2 Press button to open the
quick release buckle. Spread
harness straps apart.
3 Place child in restraint in
seated position, firmly against
both the back and bottom of
the restraint.
Securing child in the restraint
4 Place buckle tongues into
the quick release buckle.
IMPORTANT: The buckle
tongue pushed in last should
"CLICK" when it locks into
place. If it does not click,
try again or try cleaning the
buckle. See page 31.
6 Tighten harness by pulling
on the adjuster strap at the
front of the restraint.
"CLICK"
Securing child in the restraint
Note: you may need to
pull excess shoulder strap
webbing through the Quick
Release Buckle Tongues
upward towards the
child’s shoulder and then pull
on the adjuster strap. This
may need to be repeated
several times to get the
webbing fitting snugly.
IMPORTANT
Shoulder Straps must
be a firm or snug fit.
To Next Page
Loading...
Need help?
General
