2625
TO INSTALL:
First make sure there is noth-
ing in or on the base (blankets,
toys etc). These may stop
the restraint from latching in
securely.
Lower the restraint down into
the base. Listen for a "CLICK"
from the latches in the base.
Pull up on the restraint to en-
sure it is securely latched.
TO RELEASE:
Lift the restraint with one hand
while pulling up on the release
latch at the back of the base.
"CLICK"
Installation - Restraint
This child restraint has a
tether strap permanently at-
tached to the base.
WARNING
Straps may be dam-
aged by unsecured
cargo in a collision.
Secure or remove
hazardous cargo
before using this strap.
Hatchback or wagon:
Do not use the child
restraint where this
strap may fall into a
split in the seat back.
Always attach hook
and remove slack.
Always use this tether strap.
Connect the tether strap to
the built-in anchorage fitting
in the vehicle, or if there is not
one available, install the an-
chor fitting supplied with this
restraint by following these
instructions.
NOTE: the tether strap wraps
around the sides of the re-
straint, not over the top.
Tether Strap - Use