Need help?Do you have a question about the Joie gemm I0911DA and is the answer not in the manual?
General| Product Code | I0911DA |
|---|---|
| Type | Infant Car Seat |
| Group | 0+ |
| Weight Limit | 0-13 kg |
| Installation | Vehicle seat belt or base (sold separately) |
| Safety Standards | ECE R44/04 |
| Harness System | 5-point harness |
| Dimensions | l 65cm x w 43.5cm x h 58.5cm |
| Headrest | Adjustable |
| Side Impact Protection | Yes |
| Removable Cover | Yes |
| Isofix | Compatible with base |
Use as shown, ensure firm fit, no alterations, and proper anchorage points.
Supervise children, ensure snug harness, avoid loose straps, never leave unattended.
Avoid front airbags, use anchorage points, consult manual/fitting station.
Use rearward-facing until shoulders reach marker (approx. 6 months).
Secure harness, check for hot surfaces, no damaged straps or unauthorized products.
Avoid placing carrier near edges or on soft surfaces to prevent falls or suffocation.
Ensure harness straps are snug, not loose, to prevent strangulation.
Check base connection and install only in forward-facing vehicle seats.
Never install the restraint in a seat with a front airbag.
Insert buckle tongues until they click, then tighten harness using adjuster strap.
Verify harness is snug around child's waist and shoulders, not interfering.
Shoulder straps must be in slots nearest child's shoulders, not lower.
Pull harness loop through slot and re-attach to splitter plate for correct height.
Straps must pass under steel bars, not over. Ensure straps are not twisted.
Keep child rear-facing if neck muscles cannot support head.
Install in forward-facing vehicle seat, rear seat center preferred, avoid side/rear facing.
Correct positioning ensures maximum protection in a crash.
Position base on seat, use recline adjustment to align bubble between black patches.
Route belt through 'Belt Path', buckle it, ensure both belts under blue lock-off.
Check belt engagement, lock-off, and level indicator bubble is in the clear area.
Always secure the base with a vehicle belt, even when restraint is not fitted.
Vehicle belts must be pulled tight; do not have any slack in the belts.
Tether strap is permanently attached and must always be used.
Secure or remove hazardous cargo; straps may be damaged by unsecured cargo in collision.
Do not use where strap may fall into a split in the seat back (e.g., hatchback/wagon).
Do not drill through fuel lines, wiring, or speakers; protect straps from sharp edges.
To Next Page
