42 43
Install Using Lap/Shoulder Belt:
INSTALL USING ONLY ONE METHOD.
NEVER install using BOTH seat belt and LATCH.
Only install in a forward facing vehicle seat.
1 - Place the child restraint in the vehicle facing the back of the car.
2 - Thread your vehicles lap belt under BOTH lap belt guides.
3 - Make sure the LEVEL LINE on the restraint label is LEVEL
WITH THE GROUND. A rolled-up towel or pool noodle may be
used to adjust the recline of the child restraint.
4 - Press firmly into the middle of the child restraint while pulling
the vehicle’s shoulder belt to tighten.
5 - Lock the lap/shoulder belt using your car’s locking
mechanism (check your vehicle owner’s manual). If your vehicle
seat belt doesn’t lock, use a locking clip.
1 2
3
4
Check Install!
Blue level line must be level with ground.
Vehicle belt is buckled and is as tight as possible around
the child restraint. Vehicle belt is not loose or twisted.
Child restraint should be stable and not move side to
side more than 1 inch (2.5 cm) at belt path.
To Next Page
Loading...
