(10)
WHAT TO DOPROBLEM POSSIBLE CAUSE
continued:
Water does not
flow right away or
at all:
• Due to high temperature and for
safety reasons, the tank is not
under pressure causing a slight
delay in water flow.
• Make sure all valves on water supply are open.
• Check hose from faucet for twisting or tight bending.
• Check if quick-connect filter screen or faucet filter screen is
clogged (see faucet manual).
Water boils or
vapor appears:
• The thermostat may be set too
high.
• Lower temperature setting by turning thermostat control dial
counterclockwise.
Hot water drips or
sputters from
faucet:
• The thermostat may be set too
high.
• Turn thermostat control dial counterclockwise.
• Check that the hose connecting the faucet to the dispenser
tank is not clogged, twisted or kinked.
• If quick-connect fitting is connecting cold water supply,
check for a clogged filter screen in quick-connect fitting (see
CLEANING AND MAINTENANCE of faucet manual).
• Check for proper installation of tubing from faucet to
dispenser tank and faucet to water line. If connected
backwards or cross-connected, valve may be damaged.
Joneca Corporation
4332 E. La Palma Avenue Anaheim, California 92807 Telephone: 714.993.5997 Fax: 714.993.2126
Website: www.Joneca.com E-Mail: ContactUs@Joneca.com
Call Our Toll Free Help Line
888.8JONECA
To Next Page
Loading...
