English – 23
Maintenance
Checking the cutting unit’s
parallelism
Check the cutting unit’s parallelism as follows:
1 Check the air pressure in the tyres 60 kPa / 0.6 bar / 9 PSI.
2 Place the machine on a flat surface.
3 Measure the distance between the ground and cutting
unit’s edge at the front of the cover.
The cutting unit should have a slight slant, with the rear
edge 2-4 mm (1/8”) higher than the front edge.
Adjusting the parallelism of the
cutting unit
1 Check the air pressure in the tyres 60 kPa / 0.6 bar / 9 PSI.
2 Remove the front cover.
3 Loosen the parallelism stay’s nuts, the inner nut has a left-
hand thread.
4 Screw out (extend) the stay to raise the rear edge of the
cover. Screw in (shorten) the stay to lower the rear edge
of the cover.
5 Tighten the nuts after adjustment.
6 On completion of the adjustment the unit’s parallelism
should be re-checked.
7 Fit the front cover.
Service position for the cutting unit
FR 2213 MA, FR 2215 MA, FR 2215 MA 4x4
The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
1 Position the machine on flat ground. Apply and lock the
parking brake. Set the cutting height control in the lowest
position and lift up the cutting unit.
2 Release the clip on the front hood and lift off the fender.
3 Loosen the spring on the drive belt's belt idler by pulling
the spring eye.
4 Place the spring eye in the holder.
5 Lift off the drive belt and hang on the load-relieving hook.
1
2
To Next Page
Loading...
