24 – English
Maintenance
6 Loosen on the cutting height stay and place in the holder.
7 Grip the front edge of the unit and pull forwards until it
stops.
8 Lift the unit until it stops and a clicking sound is heard.
9 The unit locks automatically in the vertical position.
Restoring from service position
1 Grip the front edge of the unit and loosen the lock, fold
down and slide in the unit.
2 Replace the cutting height stay and the belt. Tension the
belt with the belt adjuster.
3 Fit the front cover.
4 Set the cutting height control to one of the positions 1-7
Checking the blades
To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades’ attachment screws are tight.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the service centre assess
whether the blade can be sharpened or must be replaced.
FR 2213 MA, FR 2215 MA, FR 2215 MA 4x4
• Put the unit in the service position, see Service position
for the cutting unit.
FR 2213 RA
• Lift up the cutting unit
• Set the cutting height control in the highest position.
• Inspect the blades from underneath.
IMPORTANT INFORMATION
Replacing or sharpening the blades should be conducted
by an authorised service workshop.
!
WARNING! If the blades are cracked,
whether caused by poor repair or other
damage, they could break while being used.
The risk increases if the blades are poorly
balanced.
To Next Page
Loading...
