Jonsered L4621 User Manual (English)

Questions and Answers:

E
Emily WardAug 13, 2025
Why Jonsered L4621 Lawn Mower does not start?
- C
  Cathy GonzalezAug 13, 2025
  Your Jonsered Lawn Mower might not be starting due to several reasons. It could be due to an incorrect starting procedure, so review the starting instructions. Other potential causes include a clogged air filter (clean or replace it), an empty fuel tank (refill it), a defective spark plug (replace it), or a disconnected spark plug cable (check the connection). Also, check for a loose blade or broken blade adapter (tighten or replace). If your model has a fuel valve lever, ensure it is in the ON position. For models with a battery, ensure it is charged and correctly connected. If the engine brake handle is defective, contact an authorized service workshop.
A
Alyssa TurnerAug 16, 2025
Why does my Jonsered Lawn Mower drive start feeling slow?
- M
  mooremaryAug 16, 2025
  If your Jonsered Lawn Mower's drive starts feeling slow, it may be due to belt wear. Also, it could be caused by a worn, damaged, or untensioned clutch wire.
P
Patrick HolderAug 21, 2025
What to do if Jonsered L4621 has less power?
- M
  meyerskristinAug 21, 2025
  If your Jonsered Lawn Mower has less power, it might be because the height of cut is too low (raise it). Another cause could be a clogged air filter, so clean or replace it if necessary. Also, check for any buildup of grass, leaves, and trash under the mower and clean it. Make sure that there is not too much oil in the engine. Finally, ensure that you are not walking too fast while cutting; reduce your walking speed.
M
Melissa OrtizAug 25, 2025
Why is my Jonsered L4621 Lawn Mower starter rope hard to pull?
- C
  Christina StewartAug 25, 2025
  If the starter rope on your Jonsered Lawn Mower is hard to pull, it could be because the engine flywheel brake is engaged when the engine brake handle is released. Depress the engine brake handle to the upper handle before pulling the starter rope. Other potential causes include a bent engine crankshaft or a broken blade adapter, in which case you should contact an authorized service workshop or your service agent. Also, check the starting procedure.
J
Johnny HutchinsonAug 28, 2025
What causes uneven mowing with a Jonsered L4621?
- C
  Christopher DavisAug 28, 2025
  Uneven mowing with your Jonsered Lawn Mower can be caused by a worn, bent, or loose blade, so replace the blade if it is bent or damaged. Also, check that all wheel heights are set at the same level. Buildup of grass, leaves, and trash under the mower can also cause unevenness, so clean the underside of the mower housing.
L
Loretta LeonardSep 1, 2025
What to do if Jonsered L4621 has excessive vibrations?
- P
  Patrick GreeneSep 1, 2025
  Excessive vibrations in your Jonsered Lawn Mower can be due to a worn, bent, or loose blade; replace the blade if it is damaged. Another potential cause is a bent engine crankshaft, in which case you should contact an authorized service workshop.
K
Katherine TaylorSep 4, 2025
What to do if Jonsered L4621 grass catcher not filling?
- J
  jmarksSep 4, 2025
  If the grass catcher on your Jonsered Lawn Mower is not filling, the cutting height might be too low, so raise it. A worn blade could also be the cause, so replace it. Additionally, check if the catcher is not venting air properly and clean or inspect the grass catcher.