7
!
4 Repair work
It is essential that you use the torque values shown in the drawings. Worn,
damaged and torn parts must always be replaced.
Repair welding is not allowed.
►
Repair work is to be completed by trained personnel.
►
Repair work is to be completed with suitable tools
using state of the art methods.
►
The item numbers in the drawings refer to the spare
parts lists in sections
.
►
Instructions for assembly are marked with a diamond
►
The assembly work is to be completed following the
instructions for removal in reverse,
unless described separately.
►
The torque values shown in the drawings are required for the assembly procedure.
►
Clean all the parts thoroughly before assembly.
►
After completing the work, grease the locking mechanism and check that it works.
To Next Page
Loading...
