3
ENGLISH
1.0 General information
Electronic Flame Controller ERS 01 manual constitutes a
supplement to an operation and maintenance manual of a
fireplace or fireplace insert. Installing the fireplace or fireplace
insert ought to be carried out in compliance with its operation
and maintenance manual.
Careful study of the manual’s content ensures easy and
correct mounting and safe use of the system.
Mounting and installing the fireplace ought to comply with
the local construction regulations.
Electronic Flame Controller ERS 01 controls the entire
combustion cycle from the initial kindling stage to the
final fire extinguishing stage. The uniqueness of ERS 01
lies within the software which was tailor-made for the
selected Jøtul and Scan fireplaces and fireplace inserts. The
Electronic Flame Controller has also been equipped with
Uni 270 software which enables the use of ERS 01 with
any fireplace equipped with an external combustion air
inlet.
With the first activation of the product, the controller takes
over all the functions responsible for regulating the amount
of air required for the combustion process. According to
the chosen mode of operation, the controller automatically
ignites, maintains the set temperature within the range
+/-5°C and safely extinguishes fire in the fireplace. ERS
01 informs the user about any fuel shortage and low
temperature of exhaust gas. The device also alerts the user
about the risk of overheating and in eect it prevents the
fireplace from damage. When the combustion cycle is over,
the throttle is shut in order to preclude both the fireplace
and the accumulating mass HSS from cooling down.
WEEE 2002/96/WE directive
Purchased product is designed and made of materials of highest
quality which can be recycled and reused.
If the product is labeled with the above symbol of crossed out
waste bin, it fulfills requirements of the
2002/96/WE European Directive
It is recommended to get acquainted with a local system of
utilization of electric and electronic products.
It is recommended to act accordingly to local regulations
and not to throw used products to containers together with
household waste. Appropriate utilization of old products can
avoid potential negative consequences of influence on people
and environment.
Storage of documentation
This assembly and operation manual, as well as any other
applicable documentation, should be stored diligently, so that
it was available at any time. In the case of moving or selling the
device, the attached documentation should be forwarded to
the new user.
2.0 Technical data
Available types of ERS 01
Measurement inputs: exhaust gases temperature (Tc),
terminals 11 and 12
Other inputs/outputs: T h r o t t l e c o n t r o l
and supply output:
•5V/150mA supply,
terminals 14 and 15;
•3.3V/max 3mA control,
terminals 13 and 14;
Regulator supply: 230V, I=0,02A, 50Hz
Rated impulse voltage: Rated impulse voltage
Operation conditions 0° ≤ Ta ≤ 40°C, 10-90%humidity,
without condensation
Casing protection level: IP 20
Weight:
~
280 g (only regulator)
Dimensions WxHxL: 140x36x99 mm
Table of temperature measurement accuracy
Internal structure: K-type thermocouple
Accuracy: ±1% of range
Displayed range: Tamb*÷1150°C
*ambient temperature of the regulator
Set content
Regulator ERS 01 1 pc.
Tc temperature sensors (K-type thermocouple) 1 pc.
PPD 100 intake air throttle 1 pc.
Remote control 1 pc.
User and installation manual 1 pc.
Attention! Connecting cables are not included in the set. To
learn about parameters of the cables admitted for use, see
section 4.2.1.
Electronic Flame Controller ERS 01 is equipped with software
dedicated for the following models of fireplaces and fireplace
inserts:
• Jøtul I 18 Panorama, Jøtul I 18 Harmony
• Jøtul I 400
• Jøtul I 570
• Jøtul F 160
• Jøtul F 260
• Jøtul F 350
• Jøtul F 360
• Jøtul F 370
• Jøtul F 400
• Jøtul F 470
• Jøtul F 500
• Jøtul F 600
• Scan 57
• Scan 58
• Scan 62
• Scan 63
• Scan 64
• Scan 85
• Scan 1001
• Scan 1002
• UNI 270 - universal software for fireplaces of other fireplace
manufacturers (only for fireplaces with an external air
inlet)