EasyManuals Logo

Jøtul F 400 User Manual

Jøtul F 400
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
1. Remove the doors from the stove and place on a flat
surface.
2. Carefully remove all of the glass clips from the inside
of the doors.
3. Gently remove the glass panel and gasketing.
4. Remove all remaining debris from the glass area using
a wire brush.
5. Apply a small bead of gasket/stove cement and the
new gasket. Do not overlap the ends of the gasket
rope.
6. Center the new glass panel over the gasket and
reinstall the glass clips. See figure 13.
7. It may be necessary to retighten the glass clips after
the stove has been burned and the gasketing has been
seated.
IMPORTANT: The side of the glass treated with an infrared
coating (marked on the perimeter) should always be facing
outward. It is extremely important to tighten the glass
clips slowly and in a repeating pattern, like tightening the
lugs on an automobile wheel.
General Maintenance
Like your car, regular maintenance prolongs the life of your
appliance. The following procedures do not take long and
are generally inexpensive, but when done consistently,
increase the life of your appliance and in turn, increase
your years of enjoyment.
At least once a year you should perform the following
maintenance procedures:
Thoroughly clean the stove. Enamel surfaces should
be cleaned with soap and water.
Empty stove of all soot and ashes. Only use a vacuum
for this job if the vacuum is specifically designed for
ashes.
Inspect the stove; using a strong light inspect the stove
inside and out for cracks or leaks. Replace all cracked
parts and repair any cement leaks with furnace
cement.
Gaskets
Check door and window gaskets for tightness. To check
the seal of the front doors, close and latch the doors on a
dollar bill and slowly try to pull the dollar bill free. If it
can be easily removed then the seal is too loose. Check
several spots around the door, and repeat the procedure
on the ash pan door as well.
If gaskets need to be replaced, scrape out the old gasket
and cement and clean the area with a wire brush. Apply a
small bead of cement and push in the new gasket. After
closing and latching the doors wipe clean, any excessive
cement that has come from beneath the gasketing.
Gasket list for the F 400 Castine
Part Cat.no Gasket type Length
Ash house 129644 1/4” SA 3'
Ashdoor 100038 3/8" LD 2’7"
Baffle 129644 1/4” SA 7’4"
Burnplate left 200028 3/16" SA 7"
Burnplate right 200028 3/16" SA 7"
Smoke Tube 129644 1/4” SA 3'
Left Door 100038 3/8" 2’6"
Glas, Left Door 200028 3/16" SA 3'
Right Door 100038 3/8" 4'
Glas, Right Door 200028 3/16" SA 3'
Top 100038 3/8" 5’7"
The F 400 Castine is designed to burn cleanly and
efficiently when used according to the guidelines
expressed in these operating instructions. However, to
maintain the proper performance, a yearly chimney
inspection and cleaning in necessary. Failure to keep the
chimney system free of creosote and build up could result
in a serious chimney fire.
Accessories
Many accessories have been manufactured for use with
the Jøtul F 400 Castine. Only use accessories that are
specifically designed for the Jøtul F 400 Castine.
Firescreen (part # 129650)
The F 400 Castine has been approved for use as an open
fireplace, with front door open. This feature is especially
nice when the ambience of a fire is desired. Some care
should be taken when operating the stove as a fireplace.
Always have the firescreen in place, attached to the
stove front.
Never overload the stove, for the best appearance burn
in the traditional three log configuration.
Reminder, when burning the stove with the screen in
place, you are sacrificing efficiency for aesthetics, and
you will be consuming wood at a much faster rate.
WARNING: Operate your Jøtul F 400 Castine with the front
doors fully open and the firescreen in place or fully closed.
Partially opened doors may result in overfiring. Also, if the
doors are left partly open, gas and flame may be drawn out
of the stove opening, creating risks from both fire and smoke.
Outside Air Kit (part # 154335)
In certain installations it may be necessary to provide
outside air to your F 400 Castine wood stove. Guidelines
to determine the need for additional combustion air may
not be adequate for every situation. If in doubt, it is
advisable to provide additional air.
USA

Table of Contents

Other manuals for Jøtul F 400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jøtul F 400 and is the answer not in the manual?

Jøtul F 400 Specifications

General IconGeneral
BrandJøtul
ModelF 400
CategoryWood stove
LanguageEnglish

Related product manuals