2
Installation and Operating Instructions for USA
Installation et fonctionnement pour Canada
Safety notice: If this solid fuel room heater is not properly installed, a house fire may result. For your safety, follow
the installation directions. Contact your local building or fire officials about restrictions and installation inspection
requirements in your area. Kindly save these instructions for future references.
Avis de sécurité: Une installation non appropriée de ce poêle de chauffage risque de provoquer un incendie. Assurez
votre sécurité en respectant les directives d`installation suivantes. Consultez les autorités locales du bâtiment ou de
la prévention des incendies au sujet des restrictions et exigences relatives aux inspections d`installations dans votre
région.
Tested and listed by ITS Intertek Testing Services, Middleton, Wisconsin.
Tested to U.S. Standards: ANSI/UL 1482, Canadian Standards: CAN/ULC-S627-M93
Standards
The F 400 Castine woodstove has been tested and listed
to;
U.S. Standards: ANSI/UL 737 and ANSI/UL 1482.
Canadian Standards: CAN/ULC-S627-M93
Tests performed by:
ITS, Intertek Testing Services, Middleton, WI
Manufactured by:
Jøtul A.S.A., P.O. Box 1411, N-1602 Fredrikstad, Norway
Distributed by:
Jøtul North America, P.O. Box 1157
400 Riverside Street - Portland, ME 04104
This heater meets the U.S. Environment Protection
Agency’s Emissions limits for wood heaters manufactured
and sold after July 1, 1990.
Under specific test conditions, this heater has shown heat
output at rates ranging from 12,000 to 35,000 BTU’s per
hour.
Important: The Jøtul F 400 Castine woodstove is only
listed to burn wood. Do not burn any other fuels.
Read this entire manual before you install and use your
new room heater.
Save these instructions and make them available to
anyone using or servicing the stove.
Jøtul F 400 Castine Woodstove
When installing, operating and maintaining your Jøtul F
400 Castine woodstove, follow the guidelines presented
in these instructions, and make them available to anyone
using or servicing the stove.
A number of areas require a building permit to install a
solid fuel burning appliance.
In the U.S., the National Fire Protection Association’s Code,
NFPA 211, Standards for Chimneys, Fireplaces, Vents and Solid
Fuel Burning Appliances, or similar regulations, may apply
to the installation of a solid fuel burning appliance in your
area.
In Canada, the guideline is established by the CSA
Standard, CAN/CSA-B365-M93
,
Installation Code for Solid-
Fuel-Burning Appliances and Equipment.
Always consult your local building inspector or authority
having jurisdiction to determine what regulations apply
in your area.
Do not connect to any air distribution duct or system.
USA
Stoves and fireplaces must be installed to conform to local and national building regulations. Before preparing for the installation of the appliance,
it is important that the instructions issued with the unit are carefully read and strictly adhered to. Jøtul pursue a policy of constant product development.
Products supplied may therefore differ in specification, colour and type of accessories from those illustrated and described in the brochure.
Jøtul vise sans cesse à améliorer ses produits. C’est pourquoi, il se réserve le droit de modifier les spcifications, couleurs etéquipement sans avis
prélable.
To Next Page
Loading...
Need help?
General
