Joyor F Series - Error Code Indicator

20 21
ENEN
P06: Wheel diameter
Unit:inch.Precision:0.1.
P07: Number of measuring magnets
Range:1-100.
P09: Start Model
0:zerostartand1:non-zerostart.
P12: Starting torque
Range:0-5.0:theweakestand5:strongest.
P15: Motor drive signal percentage settings
Fullspeedissetto100.
P16: Cruise control function
1:activatedand0:deactivated.
P17: Light settings
Thelightsarenotlitautomaticallywhenthevehicleison,0:the
lightsarelitautomaticallywhenthevehicleison.
P99: Setting reset
WheninP99settings,pressandholdtheMbuttonfor
5-6secondstoresetalltheparametersbacktotheinitial
settings.
Error Code Indicator
Whenthesymbol!isashing,shortpressON/OFFswitch
buttontoenterintotheerroranalysismode.Eachnumberof
theerrorcodecorrespondstoaspecicproblemasfollows:
NO.
Error
Code
Definition
1 ERRO 1 Motorfailure
2 ERRO 2 Acceleratorthrottlefailure
3 ERRO 3 Controllerfailure
4 ERRO 4 Brakefailure
5 ERRO 5 Undervoltageprotection
6 ERRO 6
Communicationfailure,thedisplaycannot
receivetheoutputfromthecontroller
7 ERRO 7
Communicationfailure,thecontroller
cannotreceivetheoutputfromthedisplay