6. Photocell input (NC)
During pause: Reloads pause
During closing: Reverses motors direction
7. Photo stop input (NC)
During pause: Reloads pause.
During closing: Reverses motors direction.
During opening: stops the motors and waits till contact returns close.
8. Analog opening edge input (8K2 ohm)
Waiting an opening command: inhibits opening
During opening: reverses motor direction for 1 second.
If not used left unconnected.
9. Analog closing edge input (8K2 ohm)
Waiting a closing command: inhibits closing.
During closing: reverses motor direction for 1 second.
If not used left unconnected.
10. Common
11. Stop input (NC)
It always stops motors and blocks control unit activity.
12. Common
13-14. Power supply output
12Vdc 250mA
15-16. Electric lock output
17-18. Flashing light output
12/24V 1A
19-20. Output motor 1
8A
21-22. Output motor 2
8A
TR1. Slowing down speed trimmer
TR2. Obstacle detection sensibility trimmer.
TS1-TS3. Buttons up/down
TS2. Enter button
DSP. Display
FS3-FS4. Transformer input 12-20Vac / 100-200VA
F2. Battery fuse 10A Fast
FS1-FS2. Backup battery input 12/24Vdc
J1. Back up battery voltage selector 12/24V
To Next Page
Loading...
