JP Selecta UV 2005 - Kinetics Mode

MANUAL DE INSTRUCCIONES CODIGO 80243 REV A Enero /11 (Sujetas a modicaciones sin previo aviso) Pag.: 44
J.P. SELECTA s.a. Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España Tel 34 93 770 08 77 Fax 34 93 770 23 62
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(Fig. 27)
Move the cursor on the unit you need, then press [ENTER]. You can also press the
number ahead of the unit directly by means of the numeric keypad.
Press [RETURN] to go back to the pre-testing screen.
Blank
Pull the blank solution cuvette into the light path, and then press [ZERO].
Test and Print
Pull the unknown concentration sample into the light path, then press [START], and
it will enter the testing screen. Press [START] again, you’ll get the concentration of
the sample. (Fig. 28)
The operation is the same if you have more samples to test.
Press [PRINT] to print the test results. All the data will be deleted after printing.
You can also delete the test results by pressing [CLEAR].
6.3 Kinetics Mode
Move the cursor onto Kinetics by pressing [»] and [«] in the main menu, then press
[ENTER] to go into kinetics pre-testing screen. (Fig.29)
Figure 27
Figure 28
Figure 29