NXU-2A Operations Manual
Interoperability Now! 3-3
With the serial cable connected and the PC running a terminal program set to the above
parameters, apply power to the NXU-2A. Wait at least 10 seconds after power up of the NXU-
2A and type +++ (three plus signs) on your keyboard. You must type all 3 ‘+’ characters within
1 second. Do not type anything else, only the 3 ‘+’ characters. The NXU-2A should respond
with ‘OK’. At this point, you are in Command Mode, and you will be able to issue
configuration commands to the NXU-2A.
NOTE: If you type the three plus signs into your terminal program and they
appear on the screen, the NXU-2A is already in the COMMAND Mode.
Configuration Mode Command Set
Type HELP and press the ENTER key. The NXU-2A should respond with:
NXU-2A Commands:
BAUD BCAST CMDPORT CONMODE
CONN COR CORINH DATA
DISC DUPLEX ECHO GATEIP
HANGTM HELP MAC MYIP
NAME PARITY PASS PORT
REBOOT SAVE SECURITY SRVRIP
SRVRPORT STAT STOP SUBNET
TRAN VER VOCODER WHAT
BOOST RXDELAY TXDELAY VSENSE
Type HELP followed by a command to get help on that command.
Save changes with the SAVE command.
NOTE: If you decide that you don’t want to make any changes to the NXU-2A
settings then you should place the NXU-2A back into the TRANSPARENT
Mode. The TRAN command should be used to do this, placing the unit back
into the data mode.
To Next Page
Loading...