JR PCM9X II - Flaperon and Rudder Mixes; Flaperon Mix

www.modelflight.com.au – World’s best source of JR products
Step #26
A
ile
r
on-to-Flap
–
C
r
uise Mode
This function gives added roll response by mixing
ailerons to flaps such that the entire trailing edge
functions as an aileron. In FUNC. L IST rotate the
Selector until A I L ⁄ F L P M is highlighted. Press the
Selector to access the Aileron-to-flap mix. Rotate the
Selector to highlight CRU then press the Selector
selecting P os 1. This will apply the same vales as
selected previously in the launch mode to the cruise.
A
lternatively, you can choose a different aileron-to-flap
value for the switches selecting P os 0. In this case selec
t
P os 0 and adjust the P os 0 value to achieve the desired
results. Press the L IST button to return to the
Function Mode screen.
Step #27
A
ile
r
on Dif
f
e
r
en
t
ial
–
C
r
uise Mode
In FUNC. L IST rotate the Selector until DIFFEREN. is
highlighted. Press the Selector to access the Aileron
differential menu. Rotate the Selector to highlight the
cruise aileron value then press the Selector to access
that value. With the flight mode switch in the middle
cruise mode, give a full right aileron command and
rotate the Selector to achieve the desired aileron
differential for cruise. Pressing the Selector will store
the value. Now rotate the Selector to highlight the
cruise flap value and adjust it to the desired position.
Press the LIST button to return to the Function Mode
screen.
19 Sail
p
lane P
r
o
g
r
ammin
g
Guide