To Next PageTo Next Page
Need help?Do you have a question about the JR PCM9X II and is the answer not in the manual?
Diagram of transmitter controls with labels for sticks, trims, and switches.
Table linking switch labels to functions in Airplane, Sailplane, and Heli menus.
Foundational programming: model name, reset, modulation, data transfer.
Functions for optimizing flight characteristics and response.
Assigning flight modes, levers, motor, and auxiliary channels.
Selecting V-tail, dual flap, or single flap servo configurations.
Enabling or disabling channels for use as slave channels or in mixes.
Adjusting sensitivity and increments for trim levers.
Adjusting control response with dual rates and exponential.
Setting servo direction to normal or reverse for each channel.
Fine-tuning servo arm alignment for precise control.
Adjusting servo travel range independently in each direction.
Mixing elevator input to flaps for enhanced pitch authority.
Mixing aileron input to flaps for improved roll response.
Adjusting aileron/flap travel to reduce adverse yaw and improve turning.
Programming servo transition delays between flight modes.
Independent flaperon/elevator adjustment via side lever.
Mixing aileron input to rudder to reduce adverse yaw.
Using spoiler stick for landing flap/elevator control.
Independent up/down flap adjustment per flight mode.
Utilizing spoiler stick for throttle control and other functions.
Defining non-linear mixing curves with up to 7 points.
Setting up linear mixing between master and slave channels.
Setting up integrated, countdown, or stopwatch timers.
Displaying and adjusting preset servo positions across flight modes.
General