JR PCM9X II - Device Select - Activating and Assigning Flight Modes

7 Sailplane Section
Device Select - Activating and Assigning Flight Modes
In the factory default setting, all flight modes are
inhibited. Flight modes are activated and assigned to
the desired switch position using the SPEED and LAUN
functions in the Device SEL screen.
In system mode list rotate the Selector until Device
SEL is highlighted. Press the Selector to access the
Device Select screen.
To activate the launch, cruise, and land mode, rotate
the Selector until LAUN is highlighted and then press
the Selector. The following screen will appear:
At this point, you must decide which 2- or 3-position
switch you prefer to assign the launch/land flight modes
to. If a 2-position switch is selected, launch and cruise
will be active. If a 3-position switch is selected, the
launch, cruise and land will be activated. We
recommend starting with the Flap (left 3 position)
switch, as this is a convenient place. Rotate the
Selector until the desired switch is highlighted and
press to select.
Trims may be selected to be either common (COM) or
individual for each flight mode. Refer to the TRIM:COM
function in the ACRO section of this manual for a full
description.
AIL D/R Aileron dual rate switch
ELE D/R Elevator dual rate switch
RUD D/R Rudder dual rate switch
BTFL SW Butterfly switch (labelled Gear)
FMOD SW Right 3-position
Flight Mode switch
AUX4 SW Left 3-position Flap switch
MOTO SW Mix switch