5 Sailplane Section
System Mode – Functions Specific to GLID mode
System mode contains the foundational programming.
System mode screens include model name, model
reset, modulation, data transfer, etc.—functions that are
typically set once and then are seldom changed or
adjusted. This section describes system functions that
are specific to the glider mode. The system functions
that are common to all 3 model types are described in
the common section at the front of this manual.
To enter System Mode–
Press ENT and hold while turning on the transmitter.
The screen should appear as follows.
System mode contains the following Glider specific screens:
Device Select Pg. 5
Trim Step Pg 11
Wing Type Pg 10
To Next Page
Loading...
