29 Sailplane Section
Servo Monitor
Sophisticated internal programming allows preset trim
positions for the elevator, flaps and flaperons (and the
aileron and rudder). The system can remain active in
flight, allowing you to fine trim presets in each flight
mode or can be locked in so they cannot be altered in
flight. Flight mode presets are automatically selected
via the flight mode switch and are adjusted with the
digital elevator trim, the digital flap trim and the digital
auxiliary trim (flaperon). While the presets are adjusted
via the digital trims, their positions are recorded in the
servo monitor.
To access the servo monitor, in FUNC.LIST rotate the
Selector until MONITOR is highlighted. Press the
Selector to access the Monitor menu then press the
Selector again to access the camber digital preset
screen. To adjust the presets, move the flight mode
switch to the launch mode (up) position. Adjust the
preset positions via the flap trim, auxiliary trim and
elevator trims on the transmitter. The values will be
displayed in the screen and then will be memorized for
that flight mode. If you wish to have these preset values
be fixed (not active in flight), once the values are
established return to the Trim Step screen in the
system mode and reduce the value of the desired
channel to 0. The preset values for all flight modes will
be stored and no longer accessible with the digital
trims.
To Next Page
Loading...
Need help?
General
