JR PCM9X II - GLID Mode Introduction; System Mode GLID Features; Function Mode GLID Features

www.modelflight.com.au – World’s best source of JR products
Step #2- S
y
stem Mode
Enter the S ys t e m M od e by depressing and holding the
ENT button
w
hile turnin
g
on the transmi
t
ter.
Step #3 Selec
t
ing a Model Memory
Depress the Selector to enter the model select menu.
Rotate the Selector to highlight M od e l SE L and
depress the Selector to access the 30 available model
memories. Rotating the Selector will allow memory
model selection. Choose the memory (1 œ 30) that you
intend to store the current model in, then depress the
Selector
to store that memory position. Press the LIST
button to return to
t
he SYSTEM M. lis
t
.
Step #4 Selec
t
ing Model
T
y
pe
In SYSTEM M. list, rotate the Selector until T yp e SE L is
highlighted.
Depress the Selector to access the Model
Type Selection menu. Rotate the Selector to highlight
G L ID then depress the Selector to store the
glider programming. Press the LIST button to return to
the S
y
stem Mode screen.
Sail
p
lane P
r
o
g
r
ammin
g
Guide 4