- 5 -
5.3 Function keys
The following functions can be assigned to [P0], [P1], [P2], [P3],[RED], and function keys.
If the function names are bracketed in the following explanations, the specific switch used to
activate the function depends on programming.
[P0] Key - MONITOR - also [RED BUTTON]
While in the standby condition and while pushing and
holding [P0] key,TSQL and SQL are released.
(OFF Position) (Sp mark appears and lights green LED)
After release [P0] key, only SQL is set.
Push [P0] key momentarily to set TSQL and SQL.
[RED] button on the top of the transceiver has the same
function as [P0] key.
[P1] Key - OUTPUT POWER SELECTION -
While in the standby condition, push [P1] key to select
output power in rotation as the diagram.
[P2] Key - SET MODE -
While in the standby condition, push and hold [P2] key to enter user set mode.
Push [P2] key momentarily to select the item.
Then push [ ] and [ ] to set the desired level / condition.
Available set mode functions:
z Backlight : ON, Automatic or OFF
z Beep : ON or OFF
z SQL Level : 0 to 255
z AF Min level : ON or OFF
z Battery Voltage : ON or OFF
Push and hold [P2] again to exit set mode.
Set Mode
LIGHT
BEEP
SQ
AFMIN
BATT
[P3] Key - LOCK -
While in the standby condition, push and hold [P3] key to lock the keyboards.(Appears key
mark.)
Push and hold [P3] again to exit key lock mode. (Disappears key mark.)
CH UP AND DOWN KEYS
Push this key to select the desired CH or items upward.
Push this key to select the desired CH or items downward.
P
0
P
1
P
3
P
2
2W 0.2W(LOW1) 0.2W(LOW2)
LIGT ON
LIGT AUT
LIGT OFF
BEEP ON
BEEP OFF
SQL 255
SQL 0
Normally light Off
Normally beep On
Normally beep Off
Use for strong signal
Use for weak signal
Volume is remained when set the volume
knob to the minimum
Sound level follows volume knob
When turn on the power SW, the battery
voltage appears in the display
No battery voltage display
To Next Page
Loading...
