5.3.1 Starting the OS on the D Drive to Start This Equipment ............................. 5-10
5.3.2 Executing the SSD Recovery Tool .............................................................. 5-11
5.3.3 Starting the OS on the C Drive to Start This Equipment (Automatic Recovery
of Software) ................................................................................................................ 5-12
5.3.4 Setting C-MAP Again ................................................................................... 5-12
5.4 Initialize the MFD folder of D drive .................................................................. 5-13
5.5 Rollback of the Software .................................................................................. 5-15
5.6 Update of Firmware .......................................................................................... 5-19
5.5.1 Update the CCU firmware ........................................................................... 5-20
5.5.2 Update the TOPU firmware ............................................................................... 5-25
Chapter 6. Connection to and Settings of External Navigation Equipment ............ 6-1
6.1 Connection with Radar Options ........................................................................ 6-1
6.1.1 Interswitch Unit .............................................................................................. 6-1
6.1.2 Power Control Unit......................................................................................... 6-3
6.2 Connection with VDR ....................................................................................... 6-11
6.2.1 Checking the Installation Status .................................................................. 6-11
6.2.2 VDR Interface Kit ......................................................................................... 6-11
6.3 Connection with ECDIS .................................................................................... 6-12
6.3.1 Checking the Installation Status .................................................................. 6-12
6.3.2 Connecting with the ECDIS ......................................................................... 6-12
6.4 Connection with BNWAS ................................................................................. 6-13
6.5 Subsystem Installation ..................................................................................... 6-14
6.5.1 Displaying the "Subsystem Installation" dialog ........................................... 6-14
6.5.2 Changing the subsystem configuration ....................................................... 6-15
6.5.3 Saving subsystem configuration changes ................................................... 6-17
6.5.4 SYNC Manually ........................................................................................... 6-18
6.6 Setting Up a Serial Port .................................................................................... 6-19
6.6.1 Displaying the "Serial Port" dialog. .............................................................. 6-19
6.6.2 Setting a serial port ...................................................................................... 6-20
6.6.3 To change the communication settings of the Serial Port ........................... 6-23
6.6.4 Checking the communication status............................................................
6-27
6.7 Setting Contacts (Contact Input/Output)........................................................ 6-31
6.7.1 Displaying the "Contact" dialog ................................................................... 6-31
6.7.2 Enabling the watch timer reset contact output of the CCU ......................... 6-32
6.7.3 Enabling the contact output for PWR FAIL of a CCU .................................. 6-33
6.7.4 Selecting the function to be assigned to each contact input of the SLC/ALC
To Next Page
Loading...
