JRC JMR-9230-S3 - 5 Operation Common to Target Tracking and AIS; Setting up Vectors

5 Operation Common to Target
Tracking and AIS
5.1 Setting Up Vectors
5.1.1 Setting Up the Vector Mode
1 Click the Vector/Past Position True/Relative changeover button.
Every time this button is clicked, the TT/AIS vector mode is switched between "T" and "R".
5.1.2 Setting Up the Vector Length
Set up the vector length in a range between 1 and 120 min in units of 1 min.
1 Click the Vector Length entry box.
The software keyboard is displayed.
2 Enter the vector length.
For the input method, please see "6.2 Operating with the Software Keyboard".
Vector / Past Position
True/Relative selection
button
Vector Length Entry Box
23