Page 6
Test fit the main undercarrage and pre-drill the
mounting holes. Use a felt tip pen to mark the sides of
the recess where the air line holes are needed.
Test fit the nose undercarriage and pre-drill the
mounting holes. Using a pen mark two holes for the
air lines.
Remove the main undercarriage and drill the holes for
the airlines as shown.
Remove the nose undercarriage and drill the holes for
the airlines as shown.
Drill or cut a hole as shown in the former alongside
the fuel tank mounting plate, making this large enough
for the air lines and servo extension leads. Repeat for
the other side.
Step 16
Step 17
Step 18
Step 19
Step 20
To Next Page
Loading...
