JSP Powercap Infinity - DONNING

14 15
ACCESSORIES:
Hearing protection can be added to the Powercap
®
Innity
®
by tting the Sonis
®
helmet mounted ear defenders. The Sonis
®
range of helmet mounted
ear defenders and the Powercap
®
Innity
®
have been designed to be compatible.
Fitting the Sonis
®
:
Remove the PowerCap
®
Innity
®
visor complete with the PowerCap
®
Innity
®
drive unit & visor carrier assembly. Unhook the sealing skirt from
the harness (see Removing & Replacing the Visor) and disconnect the power cable from the battery box (see Battery and Airow Check). To remove
the visor carrier, press the rear of the visor side arms towards the helmet shell and push forwards. (see Removing & Replacing the Drive Unit and Visor
Carrier Assembly).
1. Remove the visor carrier adaptors from the helmet shell. Inverting the helmet, push the adaptor blade towards the outside of the helmet and then down.
Then use a thin sharp object such as a screwdriver to push the release button on the outside of the helmet shell.
2. Fit the ear defender as the instructions supplied with the ear defender of your choice.
3. Once the ear defenders are tted, slide the visor side arms into the slot on the ear defender helmet adaptor.
• Ensure that the visor skirt is correctly attached as stated in Removing & Replacing the Visor.
• When donning the helmet, adjust the ear defenders as stated in user instructions supplied with the ear defender. Ensure that both the ear
defender and the PowerCap
®
Innity
®
are correctly adjusted and comfortable. Failure to do so may result in the levels of protection offered by
either or both units being severely reduced.
WARRANTY:
JSP Ltd warrants to its customers of PowerCap
®
Innity
®
that the device will be free from defects in materials and mechanical or electrical defects for a
period of 24 months from date of purchase in accordance with EU Directive 1999/44/EEC. This warranty is subject to:
• PowerCap
®
Innity
®
being used solely for the purpose for which it is intended.
• PowerCap
®
Innity
®
not being subject to misuse, damage, modication or repair.
• The user must register the product to enact this guarantee.
To register the product, visit www.jspwarranty.com
JSP Ltd will replace defective parts as required at no charge. JSP Ltd’s liability will not exceed the value of the original sales receipt for the device. In the
event of valid claims under this warranty JSP Ltd will not be liable for loss of use of any of its products or for any incidental, indirect or consequential cost,
expenses or damages incurred or claimed by the purchaser or any other user. No other terms are implied by this warranty but a purchaser’s statutory rights
are not affected. To make a claim under this warranty, please contact the retailer from which the PowerCap
®
Innity
®
was purchased.
BATTERY INFORMATION:
1 2 3
CLEANING:
The product should only be cleaned with a cloth lightly dampened with a mild detergent solution. Care must be taken to avoid any liquids entering the
motor/fan assembly or the lters.
Battery Type: Lithium-ion 3.6V, 5.2Ah, 18.72 Wh. The battery has an expected life of 500 cycles when charged, stored and used in accordance
with these instructions.
• Operating temperature should be between +5°C and +40°C and relative humidity not greater than 75%.
• The temperature for charging and discharging of the battery should be between +5°C and +40°C.
• Do not dismantle, open or shred the battery pack.
• Do not expose the battery pack to heat, re or microwaves. Avoid storage in direct sunlight.
• Do not short-circuit the battery pack. Do not place the battery pack haphazardly in a box or drawer where it may short-circuit with another or be short-
circuited by other metal objects?
• Do not remove the battery pack from its original packaging until required for use.
• Do not subject the battery pack to mechanical shock.
• In the event of the battery pack leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected
area with copious amounts of water and seek medical advice.
• Do not use any charger other than that specically provided for use with the PowerCap
®
Innity
®
.
• Do not use any cells or batteries which are not designed for use with the PowerCap
®
Innity
®
.
• PowerCap
®
Innity
®
is not intended to be used by children, children should not be left unsupervised with PowerCap
®
Innity
®
or its battery pack.
• Seek medical advice immediately if parts of a dismantled battery pack have been swallowed.
• Only replacement battery packs intended for the PowerCap
®
Innity
®
are recommended by JSP Ltd for use with PowerCap
®
Innity
®
.
• Keep the battery pack clean and dry.
• Wipe the battery pack terminals with a clean dry cloth if they become dirty.
• The PowerCap
®
Innity
®
battery pack needs to be charged before use. Always use the correct charger supplied with PowerCap
®
Innity
®
and refer to
the user instructions for the correct charging procedure.
• Do not leave a battery pack on prolonged charge when not in use.
• After extended periods of storage, it may be necessary to charge and discharge the battery pack several times to obtain maximum performance.
• Retain the original user instructions for future reference.
• The battery pack is only intended for use with the PowerCap
®
Innity
®
, it is not suitable for any other application.
• When possible, remove the battery pack from the equipment when not in use.
• Dispose of exhausted battery packs in accordance with local legislation.