4. Attach the feed chute.
a. Remove the bolts holding the rubber pad bracket to the rotating
plate (½-inch wrench).
b. Attach the selected feed chute to the rubber pad bracket by using
the two bolts provided (½-inch wrench).
5. Attach the rubber pad bracket to the rotating plate.
The rotating plate has 2 sets of bolt holes (Figure 9.) Use the
bolts provided to attach the rubber pad bracket to the rotating plate
described below (½-inch wrench).
• The upper set of bolt holes is for positioning the rubber pad
bracket (and attached feed chute) for both 11 and 12-inch
softball use.
• The lower set of bolt holes is for attaching a baseball chute (this
chute is also used for lacrosse and field hockey.)
Assembly
14
Figure 09
Upper Bolt Holes
Lower Bolt Holes
To Next Page
Loading...
Need help?
General
