– 70 –
2-26. Performing combination sewing
(1) Selection of combination data
First, change the sewing mode to the combination sewing before performing setting.
Refer to
"II-2-15. Winding bobbin thread" p.50
Display the data input screen.
Only in case of the data input screen (pink), it is possible to
select the combination data No.
In case of the sewing screen (green), press READY switch
to display the data input screen (pink).
Call the combination data No. screen.
When COMBINATION DATA NO. button
is pressed,
the combination data No. selection screen is displayed. Com-
bination data No. which is selected at present and the con-
tents are displayed in the upper part of the screen, and other
combination data No. buttons which have been registered are
displayed in the lower part of the screen.
Select the combination data No.
When UP/DOWN button
is pressed, combination
data No. buttons
which have been registered are changed
over in order.
It is also possible to display the combination data No. input
screen using NUMBER INPUT button
and input a
combination data No. directly.
Here, press the combination data No. buttons
you desire to
select.
When STEP CONFIRMATION button
is pressed,
the sewing shapes of patterns which have been registered in
the combination data and the like are changed over in order
and displayed.
Determine the combination data No.
When ENTER button
is pressed, the combination
data No. selection screen is closed and the selection is n-
ished.
To Next Page
Loading...
Need help?
General
