DNU-1541H
1
2
5
6
8
＊ 10
11
12
3
4
9
7
A
B
1. Attach arm thread guide
A
to the top cover with
setscrew
B
.
2. Thread the machine head following the order of
1
through
12
as shown in the illustration given above.
＊
Pass thread through the right side of thread guide
10
.
When needle thread is apt to be off from thread tension
disk
5
during sewing, pass needle thread through arm
thread guide
A
in the order of
➊
through
➍
.
➊
➋
➌
A
➍
– 24 –
Turn stitch dial
➊
counterclockwise (clockwise) so that
the number corresponding to the desired stitch length is
brought to the top until the marking spot is reached.
(1) Reverse feed stitching
1) Press down reverse feed control lever
➋
.
2) Reverse feed stitches are made as long as you keep
pressing the lever down.
3) Release the lever, and the machine will run in the
normal feed direction.
➊
➋
12. ADJUSTING THE STITCH LENGTH
– 25 –
To Next Page
Loading...
