– 6 –
Do not use the screws supplied the panel
instead of screws
supplied with the ma-
chine head.
8) Put reux pipe
in the oil reservoir
A
of oil
pan
❺
. Secure the pipe in groove
.
9) Fix lter
and lter clamp
with tting
.
10) Mount spacers
supplied with the machine
head on the frame.
11) Install bracket
on CP panel
with screws
supplied with the panel.
12) Install bracket
on spacer
with screws
supplied with the machine head and washers
supplied with the panel.
7) Securely attach head support rod
❾
until its rib
is closely pressed against the table.
❺
A
❾
When it is really necessary to conduct work
with the machine head supporting rod re-
moved for the purpose of maintenance and
repair, it is necessary to carry out the work
with two or more persons.
In the case the machine head is tilted more
than necessary, oil can leak from the oil in-
let of the oil tank. It is, therefore, necessary
to remove oil from the oil tank before tilting
the machine head.
* Accessory screw
supplied with the machine
head: Thread diameter M5; Length: 8 mm
To Next Page
