Need help?Do you have a question about the JUKI LU-2810 and is the answer not in the manual?
General| Brand | JUKI |
|---|---|
| Model | LU-2810 |
| Category | Sewing Machine |
| Language | English |
Instructions for safely moving and positioning the sewing machine.
Securing hinge seats, support rubbers, and spacers to the table for machine head mounting.
Instructions for fixing the oil pan to the sewing machine table using screws.
Guide for attaching the oil filter to the oil pan assembly.
Steps for installing hinges, head support rods, reflux pipes, filters, and brackets.
Guide for installing the pneumatic regulator assembly and associated couplings.
How to set the operating air pressure using the filter regulator knob.
Guidance on routing the exhaust tube from the machine through the table.
Steps for filling and maintaining the sewing machine's oil tank for proper lubrication.
Procedure for cleaning the oil filter and reservoir to ensure proper lubrication.
Method for adjusting the amount of oil supplied to the hook mechanism.
How to engage reverse feed stitching using the control lever.
Using the touch-back switch for manual reverse feed stitching.
Adjusting stitch length by changing the stitch pitch using a switch.
How to adjust the tension of the needle thread using tension nuts.
Method for adjusting the tension of the bobbin thread using an adjustment screw.
How to change the stroke of the thread take-up spring by moving it in a slot.
Procedure for adjusting the tension of the thread take-up spring using nuts and screws.
Steps for positioning the counter knife relative to the throat plate and moving knife.
How to adjust the pressure applied by the moving knife for thread cutting.
Correcting needle entry point alignment for normal and reverse feed stitching.
Adjusting reverse feed stitching speed based on the stitch pitch setting.
Using the switch to maximize the vertical movement of the walking foot and presser foot.
Controlling automatic reverse feed stitching for start or end of sewing.
Function of the switch to move the machine from needle-down to needle-up stop position.
Using the switch to change stitch length based on the 2P feed adjusting dial.
Selecting double tension function for increased needle thread tension.
Steps for installing the knee switch mounting plate and the switch itself.
Overview of the knee switch's primary function and alternative uses.
Configuring the knee switch functions via the machine's control panel settings.
To Next Page
