JUKI LU-2810 - BEFORE OPERATION

– 1 –
BEFORE OPERATION
• Beforeyouputthemachineintooperationforthersttimeaftertheset-up,cleanitthoroughly.
 Removealldustgatheringduringtransportationandoilitwell.
• Conrmthatvoltagehasbeencorrectlyset.
 Conrmthatthepowerplughasbeenproperlyconnectedtothepowersupply.
• Neverusethemachineinthestatewherethevoltagetypeisdifferentfromthedesignatedone.
• Thedirectionofnormalrotationofthemachineiscounterclockwiseasobservedfromthepulleyside.
 Takecarenottoallowthemachinetorotateinthereversedirection.
• Neveroperatethemachineunlessthemachineheadandtheoiltankhavebeenlledwithoil.
• Foratestrun,removethebobbinandtheneedlethread.
• Fortherstmonth,decreasethesewingspeedandrunthesewingmachineataspeedof80%orlessof
themaximumsewingspeed.Astothemaximumsewingspeed,see
"25. SEWING SPEED TABLE" p.24.
• Operatethehandwheelafterthemachinehastotallystopped.
CAUTION :
Check the following so as to prevent maloperation of and damage to the machine.